Engine Gasket Sets and Water Seals

Engine Gasket Set
NOTE: We consider the MINIMUM parts needed for an engine overhaul to be an ENGINE GASKET SET, FRONT and REAR SEALS (shown on this page) + a ROTOR KIT (shown on the ROTOR and ROTOR PARTS page, specific individual rotor parts are also available on that page if needed).		Generic Turbo Gasket Set Image
(Gasket Sets do NOT include front & rear seals, or pilot bearing and seal, these are at the end of this page)
Year(s)	Application	Part Number
76-78	12a, 13b Combo kit RX-3/4/Cosmo	99-1000-8823
79-80	12A	No Longer Available
81-82	12A	89-100A-N201
83-85	12A	89-100A-N231
84-85	13B GSLSE	89-100A-N304
86-88	Non-turbo	10-271A-8DF1
	Turbo	10-2710-8DF4
89-92	Non-turbo	10-2710-8DF5
	Turbo	10-2710-8DF6
93-95	Twin Turbo	10-2710-8DFE

Engine "O-Ring" Sets
Please note that ALL the parts in these sets ARE also in the respective full engine gasket sets!! We offer these due to the high cost of some of the FULL gasket sets. There are rare occasions where the extra gaskets may not always be needed, and purchasing one of these sets would allow BARE short block assembly without the cost of the full gasket set. Also in the case of a discontinued gasket set, this o-ring set is a good start to the rebuild.
93-95		10-S60A-N3A1
The above set contains the water seals, seals for tension bolts, dowel pins, rear gear, front cover, and metering pump, plus the teflon piece for front cover, (2) primary air bleeds, and all "o-rings" for the injectors.
89-92	Turbo	10-S600-N370
	Non-turbo	10-S600-N350
86-88	Turbo	10-S60A-N318
	Non-turbo	10-S60A-N326

Selected Seals that we also offer individually:
Rotor housing-to-side housing water seal (each part number is ONE seal)
74-85	Inner (Orange)	10-171A-1757
	Outer (Black)	10-1720-1480
86-95	Inner (Orange)	10-B71A-N326
	Outer (Black)	10-B720-N326
Tension Bolt Seal
74-95		10-4550-0839

Main Engine Parts Page