86-92 Anti-Sway Bar Links

The original equipment anti-sway bar links have an amazing amount of compliance in their rubber bushings. The 89-92 RX-7's still have compliance but are made of plastic, and we have already replaced some that were broken.
The increase in handling firmness and steering response is very noticeable when our bar links are installed, even when retaining the original anti-sway bars. The adjustable links also allow setting the bars to "zero pre-load" with the weight of whichever person is normally driving the car.

Front Links Kit H-M010F

Rear Links Kit H-M010R

Rear Suspension on 86-92 RX-7

"Rear Steer" was added to the RX-7 beginning with the 86 model. The rear geometry reacts to cornering "G" forces by changing the toe alignment on each wheel depending on the speed, loads, and body roll. The sensation the driver feels is the front wanting to steer into the corner, but is actually the rear steering to the outside of the corner. This all happens right when a sensitive driver is expecting the rear end to begin a slight slide which the driver would compensate for by some degree of opposite-lock steering input.

Installation of "Toe Eliminator" bushings negates the rear steering and returns the car to the responses a sensitive driver is expecting during "Spirited" driving. (This type of driving will only be done by experienced race car drivers on non-public, closed course race circuits of course).

Click here for a How-To, because Ash says so.

Polyurethane Bushings

Polyurethane bushings are a considerable improvement up from original equipment rubber bushings due to their firmness. They do not require nearly as much compression, compared to stock bushings, before they let the suspension begin to function.

Front Anti-Sway Bar Bushing Set

One set needed to fit the front bar. 24mm bar only.

H-95128

Front Sway-Bar end link bushings

These are pressed into the stock links (86-88 only) to replace the factory rubber bushings. One set needed for the front bar. Will not fit rear bar links.

Front Lower Control Arm Bushing Kit (86-92)

This is a really good kit that contains the bushings needed for the front and the rear pivots of the front control arm. The inner diameter has the "barb" shape to conform to the OEM arm. Complete with the needed steel sleeves and bushings to do both arms.

H-113102

Rear Lower Control Arm Bushing Kit

This kit does the front pivots of the rear lower swing arm. Complete with bushings and sleeves to do both arms.

H-113103

86-92 RX7 Full Front & Rear Urethane Kit

The front is lowered approximately 3/4" with these new strut tops. Installation is easy, especially if struts and/or springs are being changed at the same time. Fits all 86-92 except those equipped with auto adjust suspension.